Hello all. I am a new LCR 9mm owner and wanted a way to carry some spare moon clips.
I didn't see any properly sized pouches that I liked, so I ordered this Bianchi dual speedloader setup. It's actually got enough room for TWO moon clips in each pouch (four total), but not without some finesse. The bottom clip is tough to dig out, and the top one rattles around as soon as you unsnap the cover.
In about 15 minutes on a bench grinder, I adapted a couple spare car parts I had laying around to solve the problem nicely. These bolts are actually for a Chevy LS engine... You tighten them onto the valve covers and then the ignition coil assembly is attached on top of that via a nut. I ground five recesses into the nut head and then wrapped electrical tape around the bottom (so it snugs into the opening at the bottom of the pouch) and the top (to keep the upper clip from rattling around).
Hope y'all might find this useful!
-Jon
I didn't see any properly sized pouches that I liked, so I ordered this Bianchi dual speedloader setup. It's actually got enough room for TWO moon clips in each pouch (four total), but not without some finesse. The bottom clip is tough to dig out, and the top one rattles around as soon as you unsnap the cover.
In about 15 minutes on a bench grinder, I adapted a couple spare car parts I had laying around to solve the problem nicely. These bolts are actually for a Chevy LS engine... You tighten them onto the valve covers and then the ignition coil assembly is attached on top of that via a nut. I ground five recesses into the nut head and then wrapped electrical tape around the bottom (so it snugs into the opening at the bottom of the pouch) and the top (to keep the upper clip from rattling around).
Hope y'all might find this useful!
-Jon