Ruger Forum banner

Had my tupperware worked on...

3K views 10 replies 8 participants last post by  BRL 
#1 ·
I picked up a Gen 3 (after comparing to gen 4) 19 a month or so ago, and put a few hundred rounds through it.

shot great and all, but it felt like a glock....unfortunately.

Dropped it off to a local guy who is known for this stuff, and got it worked over.

Grip reduction, finger grooves removed, under cut trigger guard, rounded trigger guard, medium texture full 360 stippling job.

A few folks were all "no dont stipple an FDE!" whatever, its a tool, and now it feels like it should work better. Havent shot it in this configuration yet, but holding it next to a stock G19 the difference is incredible.

Befo'


Aftah





I need to get a decent daylight pic.
 
See less See more
5
#5 ·
I've never head much about that.

People were frekaing out because I'm going to 'ruin' or 'change' a 'rare' FDE glock. :rolleyes:

The OD ones are hard to come by, these are a limited run too I guess.

Glock doesn't make pretty guns, looks like you managed to pretty it up some. I like the trigger guard work. I have never understood the point on the front.
me neither. Maybe if you use your support hand on the front of the guard? I dont, hats for sure, just seems like it would get hung up going in/out of a soft holster.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top