Quote:
Originally Posted by SouthSideScubaSteve  I have a new, unfired Mini and an Accu-strut X-Drill sitting in my safe; but I'm not going to install it until I establish a baseline for my Mini.
I'm planning on taking it to the range and running rouds thru it from 5 different manufacturers in it's first outing. The last 5 rounds of each type will be from the bench & I plan to keep the targets. I'll bring the gun home, do a complete strip & clean, install the X-Drill strut and then repeat the exercise at the same indoor range....
I'll report the results here once i get it done!
SSSSteve |
excellent idea. i would run a couple hundred rounds through before you test accuracy though, as a break in period. my mini seemed to improve slightly just as action smoothed out a bit. be sure and check that gas block as well before committing to accuracy tests.
another thing to test would be accuracy with a hot and cold barrel before and after install of accu-strut. i've seen the best result from my strut as the ability to stay consistent after my barrel heats up.
Linear Mode
