Ruger Forum banner

rear peep sight of SR-556

7K views 15 replies 7 participants last post by  Lmstncwby 
#1 ·
I've got a new SR-556, which I've put about 350 rounds through. I've zeroed the iron sights using at 25 meters using the standard M16A2 8.5 X 11 target.

Haven't shot much with it over 50 yards at this point, but have a concern regarding the rear peep sight. I can drill the center of the target easily at 25M, but noticed that the rear aperture is about 3/4 of the way over from the left, in order to get this zero.

For you SR-556 owners, is this typical for zeroing this weapon?
 
#2 ·
Mine was not centered either and it shoots great. I was irritated at first then I had to laugh it off because that is what adjustable sights are for.
 
#3 ·
Whew. that's a relief. I was concerned I'd have to send it back to ruger to a 'crinked barrel'. or at least that's how I'd describe it and then let them figure it out. =)

Do you have any issues with right drift with the iron sights as the range increases beyond where you've zeroed it?
 
#10 ·
No. Once the sights are aligned with the barrel, and therefore bullet trajectory, you shouldn't have to mess with them anymore unless you are dealing with wind condition or are shooting at such long ranges that the spin of the bullet causes it to crawl off target. The only thing you should really need to adjust is elevation for different distances.
 
#14 ·
My rear sight needed a pretty good shift to the right to get it centered. It now is co-witnessed with my Eotech 512 so if the 512 fails for some reason, up go the iron sights and I'm back in business. As long as they line up.

I have zeroed it at 25 yards so it will be nearly dead on at 200 yards with XM193.
 
#15 ·
Mine is the same and so are my M1's
On the M1 all you need to do is loosen the big hex screw in the front sight base and move the front sight to get your mechanical zero to line up with your true zero. I mark my front sight with nail polish to index it to the base- murphy will cause the front sight to go loose when you really don't want it to!

For the SR556 having the windage off a bit isn't a big deal- you lose some windage adjustment which you would only use to shoot over 500 yards on a windy day, but likely this will never be an issue.
 
#16 ·
The 556 really is iffy at 500 yards in even the best conditions and with 68 gr bullets, so I wouldn't worry too much about the windage setting on the iron sights. Besides, you will probably use a scope at that range anyway, which negates the rail problems anyway.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top