VQ Extractor - Wear MarkThis is a discussion on VQ Extractor - Wear Mark within the Ruger Rimfires forums, part of the Pistol & Revolver Forum category; I just installed a VQ Exact Edge Extractor in my Mark III, and after just 10 rounds, I noticed this wear mark on the outer ...
 |
|
September 3rd, 2012, 03:47 PM
|
#1 |
Join Date: Sep 2011 Location: Northern VA
Posts: 136
| VQ Extractor - Wear Mark
I just installed a VQ Exact Edge Extractor in my Mark III, and after just 10 rounds, I noticed this wear mark on the outer edge of the extractor cutout in the barrel. Anything to be concerned about?  
Last edited by Captains1911; September 4th, 2012 at 05:58 PM.
| 
| | |
September 4th, 2012, 05:58 PM
|
#2 |
Join Date: Sep 2011 Location: Northern VA
Posts: 136
|
edited to add better photos
| |
| | |
September 7th, 2012, 07:34 AM
|
#3 |
Join Date: Sep 2011 Location: Northern VA
Posts: 136
|
Anybody?
| |
| | |
September 11th, 2012, 04:38 AM
|
#4 |
Join Date: Sep 2011 Location: Northern VA
Posts: 136
|
Hmmmm...Ok, so I guess nobody here even owns a Mark III that they could take quickly glance at to see if it shows similar signs of wear?
| |
| | |
September 11th, 2012, 09:18 AM
|
#5 |
Join Date: Mar 2012 Location: Las Vegas
Posts: 893
|
Hi Capains 1911
I just took one of my MKIII's out and checked it. it has the same bevel edge just not as polished looking as yours but it's there and thats with a stock Ruger extrator. This Mark has about 2000 rds thru it.
| |
| | |
September 14th, 2012, 12:23 PM
|
#6 |
Join Date: Jun 2010 Location: West Michigan
Posts: 66
|
I also have the same mark on mine. The VQ extractor is harder than the factory stamped one, which for me, started waring out and stovepiping after about 500 rounds. The VQ works much better, but I'm going to take mine out and hit it with 1500 grit sandcloth on the edge that contacts the chamber, just to lessen any problems with it.
| |
| | |
September 16th, 2012, 12:55 PM
|
#7 |
Join Date: Jul 2007 Location: , , .
Posts: 389
|
Normal with an extractor change. 
This one even has a chip-out in the extractor groove area. Again no big deal as long as extraction and insertion are smooth.
R,
Bullseye
| |
| | | Search tags for this page | | extractor wear, mini 14 worn out extractor, ruger extractor groove wearing into chamber, ruger mark ii extractor, ruger mark ii extractor cut, ruger mk extractor wear, ruger mk iii extractor, ruger mkiii extractor cut out, ruger mkiii extractor wear, signs of wear on extractor, vq exact extractor, worn ruger mark iii extractor | | Thread Tools | | | | Display Modes |  Linear Mode | |
