Originally Posted by R L Withrow
The trigger parts are the same but as with any firearm that is mass produced, the trigger feel greatly depends on the finish quality of the individual parts in each gun. Smoother finished parts with produce better feel. Mine was a little gritty in take up pull but it was dramatically improved with simple polishing of the trigger bar side, the sanding of a mold parting line in the polymer grip frame that the trigger bar rides against and especially the end of the trigger bar where it rides against the trigger bar reset. These are parts #40 and 44. The end of the trigger bar is pushed back against an angled flat on the trigger bar reset when you pull the trigger. This action completes the cocking action of the striker and also the disengagement of the sear surface in a downward motion to fire the weapon. Polishing the end of the trigger bar (that was VERY roughly finished on mine) totally eliminated the gritty feeling while pulling the trigger. I simply used a Dremel tool with a cotton buff to shine up the metal parts and 600 grit wet or dry sandpaper the sand the parting line out inside the grip frame.
Thanks for the information, I really appreciate it.
I'm a Glock lover, so I'm no stranger to polishing internal parts, lol. I'll make sure to give the 9E once over when it arrives.