Ruger Forum

greatwhitenorth · September 20th, 2012, 05:50 AM

i purchased a beat up SS that i intend to bead blast
i removed the cylinder and crane, and remove the ejector from the crane, but the crane will not pull off the cylinder? the cylinder will spin on the crane. all thats left in the crane is the ejector spring with the spline on the end?

Iowegan · September 20th, 2012, 07:02 AM

greatwhitenorth, There is a spring loaded plunger pin that holds the cylinder onto the crane. Just push the pin in and it will release.

greatwhitenorth · September 21st, 2012, 10:13 AM

i must be blind, i do not see were any such plunger would be?

Ruger Forum

crane stuck to cylinder Security Six

gp100 cylinder is stuck to crane

gp100 removing the crane from the cylinder new gp100's

how to remove crane from cyclinder on a ruger gp100

how to remove cylinder from crane of ruger security 6

remove securtity six cylinder from crane

removing a stuck cylinder crane

revolver crane stuck

ruger gp100 *crane latch pivot

ruger gp100 crane latch disassembly

ruger gp100 ejector bar stuck

ruger sp 101 crane latch stuck

ruger speed six crane stuck