Ruger Forum banner

10/22 home built bull barrel

2K views 8 replies 7 participants last post by  ngashooter 
#1 ·
Machine tool Milling Machine Tool Metalworking hand tool

This is my son's factory 10/22 barrel that I threaded for a brake. After threading I turned a shoulder on the breech end installed a piece of thin walled tubing that is captured between the shoulder at the breech and a shoulder on the brake.
 
See less See more
1
#9 ·
Nice work on the brake installation. Even better is spending time with your boy in the shop. His pride in having a hand in creating a custom barrel will make him want to learn more machining skills. I wish my Dad was more mechanically inclined when I was growing up. Our special times were jon-boat fishing the Everglades, and trolling the weed-lines in the Gulf Stream.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top